PCV RX406 sec hard drive

[crap]

I intend to fit a second HD.
I have located ribbon cable and power cable.
It looks as though i pull the clip/slide below HD cradle and it slides out.
Insert new HD and away we go.
The old one will be left in place and i presume the jumper is set already to "master"
I will have to set the add one to slave.
Does the above look about correct?
Could not find any thing on the vaio site about adding a d rive.
Thanks for pointers or any help.

[robpaxton]

Looks about right to me - you may need to set your new drive to cable select (Just look at the jumper positions on your primary drive) and set the BIOS to detect the second drive.

[crap]

"set your new drive to cable select " How do i tell where the jumpers should be?

[robpaxton]

The jumper settings are normally on a label affixed to the drive. If not then the drive manufacturers website should have the details.

[crap]

Thank you