Xperia Z stuck on Screw driver and Wrench screen when turning it on after 4.2.2 android update

[GuiCos]

I recently just updated my phone, everything went smooth, and the phone updated and booted up right, after the phone "said" it had updated everything and restored all my files and tweeked my apps, I turned off for a while

When rebooting it, I get the Sony and Xperia logo screens, but then Im presented with this Wrench and Screw Driver screen

Sorry for the bad quality pic, my Vita is the only thing I have to take a picture of it

[Uliwooly]

repeat the update process (PCC or SUS)

[Uliwooly · Accepted solution]

Update Service (SUS)

http://www.sonymobile.com/gb/tools/update-service/

http://www-support-downloads.sonymobile.com/Software%20Downloads/Update_Service_Setup-2.11.12.5.exe

PC Companion (PCC)

Bridge (for Mac)

Alternatives on How to backup Xperias

http://talk.sonymobile.com/thread/36355

Don't forget to mark the Correct Answers & Helpful Answers

[GuiCos]

Thanks,

I just tried the updater, and it gave me a Update Fail message, saying that there was not enough battery, and to try again once I've recharged

The problem is now that the cellphone is on a bootloop, it keeps going on the SONY logo screen and turning it off

and I dont know how to stop it or if its indeed charging ir properly so I can try the updater again

[Uliwooly]

connect the phone to a wall charger > press and hold power & volume up for few seconds until the phone turn off